Browsing by Author "Junemann Ureta Rosita"

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Analysis and interpretation of the seismic response of RC buildings in Concepcin during the February 27, 2010, Chile earthquake
    (2013) Westenenk Orrego Benjamin; De La Llera Martin Juan Carlos; Junemann Ureta Rosita; Hube Ginestar Matias Andres; Besa Vial Juan Jose; Luders Schwarzenberg Carl; Inaudi Bonadero Jose Antonio; Riddell Carvajal, Rafael; Jordan Sainte-marie Rodrigo
    Observed trends in the seismic performance of eight severely damaged reinforced concrete (RC) structures after the February 27, 2010, Chile earthquake are presented in this article. After a reconnaissance and surveying process conducted immediately after the earthquake, several aspects not conventionally considered in building design were observed in the field. Most of the considered structures showed extensive localized damage in walls of lower stories and first basements. Several factors indicate that damage was brittle, and occurred mainly in recent RC structures supported on soft soils with some degree of vertical and/or horizontal irregularity. Non-ductile behavior has been inferred due to the lack of evidence of spread damage in the structure, and the fact that very similar structural configurations existed nearby without apparent damage. Some key aspects in understanding the observed damage are: geographical orientation of the building, presence of vertical and horizontal irregularities, wall thickness and reinforcement detailing, and lack of sources for energy dissipation. Additionally, results of a building-code type analysis are presented for the 4 most critical buildings, and Demand/Capacity ratios are calculated and compared with the observed behavior. It is concluded that the design codes must be revised relative to wall design provisions.
  • Thumbnail Image
    Item
    Characteristics and displacement capacity of reinforced concrete walls in damaged buildings during 2010 Chile earthquake
    (2015) Alarcon Olivari Cristobal Nicolas; Hube Ginestar Matias Andres; Junemann Ureta Rosita; De La Llera Martin Juan Carlos
    About 2 % of reinforced concrete (RC) buildings taller than nine stories suffered important structural damage during 2010 Chile earthquake. The typical structural configuration of residential buildings is characterized by a large number of RC structural walls which provides high lateral stiffness and strength. The first objective of this paper is to obtain global geometric and design parameters of RC structural walls in damaged buildings and correlate their values with the observed damage. The second objective is to compare the roof displacement capacity with the roof displacement demand in critical walls, and hence, try to explain the observed damage. The wall parameters were obtained from five representative damaged structural wall buildings; these are: wall thickness, aspect ratio, axial load, reinforcement ratios, and the ratio between horizontal reinforcement spacing and the vertical bar diameter. The roof displacement capacity is obtained using a plastic hinge approach, and the ACI 318-08 approach, since both methods are proposed in the current Chilean seismic code. The displacement demand is estimated from ground motions recorded in the vicinity of the buildings. It is found that values of wall parameters correlate well with the observed damage. The structural walls were subjected to relatively high axial loads, and some walls included a large amount of vertical reinforcement to provide the required strength, but had inadequate transverse reinforcement thus compromising ductility. Findings from this research suggest that the plastic hinge approach is inadequate to estimate the roof displacement capacity and lacks correlation with the observed damage. Moreover, the use of the ACI 318-08 approach to estimate the roof displacement capacity is also inadequate, but leads to better predictions of wall displacement capacity. As shown by the results of response history analysis, the failure of walls was triggered by high axial loads rather than flexural deformation.